Five tips to keep your car

Do you want to keep your car constantly and always make it in stages of safety? ,well, read this article carefully.

1. measuring the level of the engine oil

 When measuring the level of the engine oil , the car must be in a horizontal plane, and that the engine is run until normal operation temperature and then turns off the engine by closing the
contact key and wait about 5 minutes then raise the standard engine oil from its place then clean it thoroughly with a cloth does not contain any impurities then put it place the engine again and observe the oil level so as not be higher the mark higher or lower than the lower mark.

can not measure the level of the engine in the case of rotation because it will give incorrect results.

   

     2.  tire air pressure

  When measuring tire air pressure must be cool calf because the pressure gauge after a long drive does not give correct results and this is due to the high temperature of the air inside the tire.

      

      3.   Brake fluid

  Brake fluid is supplied only in the case of leaks or when you change any of the internal parts of the drive and should the ban when it is used because it affects on the car paint and if spilled on the vehicle body must immediately poured water on it.

Becareful!

no more than the brake fluid when falling because the decline refers to erosion of brake linings so appears brake bulb in the dash board but when supplied with eroding brake linings and do not appear to brake bulb in the dash board so you should not increase it only in the case of leaks or when you change any of the internal part of the drive.

     4.  Battery cable

   when you must change or repaire any car electric parts must remove the negative battery cable and make sure the contact key is sealed ,as well as, all the lights car keys to avoid the lack of a short circuit with electric drive circuits.

    5.   High engine temperature 

  In the case of high engine temperature should stop driving immediately and the contact key must be closed then carefully open the hood and note:-

1. the existence of any leakage of water from the cooling cycle and work to fix it.
2. ensure the safe operation of the cooling fan.
3. after it cools the engine cover can be opened radiator and make sure there is water inside it.
4. ensure the safety of water bladders radiator and be inside the water up to the level required.
5. ensure radiator safety himself and the absence of any thing obscure about air.

    finished article!

 If you like write me a comment to share our views together ,how much pleasure it, i will show lots and lots of these tips in the next articles.   goodbye